Fly High Tsunami Pump Quick Twist Connector W734
Connect the Fly High Tsunami Pump or Attwood Tsunami 1200GPH ballast pump with an 1-1/8" inlet to the Quick Twist Connector that comes with Fly High Pro X Series ballast bags.
The Attwood Tsunami 1200GPH Long Intake version features a proprietary 1-1/8" thread pattern which can be difficult to interface with. This fitting from Fly High is one of only a couple that match that unique thread, making it very useful for connecting the pump in various applications.
The most common use for this fitting is for customers that are building their own portable ballast pump, rather than buying a prebuilt model. If you like to DIY and enjoy a project, you can save some money versus just buying an off-the-shelf model, and this is the fitting you will need to connect the Attwood Tsunami Pump mentioned above to the bag for draining using Fly High's Quick Connect system.
NOTE: This fitting will only work with the 1-1/8" Long Intake version of Attwood's Tsunami 1200 Cartridge Aerator Pump. If you're using the 500GPH or 800GPH version of that pump you need the 3/4" Standard Pump Quick Twist Adapter.
Fly High ballast fittings have been designed with you in mind. All of the fittings make connecting pumps and hoses to your Fly High Pro X Series Ballast Sacs™ a quick and simple task. No more struggling with old waterbed valves and water spilling inside the boat. Simply twist, pull, replace and you're ready to go! Fly High offers several different fittings that all work together to adapt to any of your needs.
works bit fitting was a size to big for my pump
I bought this to build my own pump. It works but the attwood tsunami pump I bought had a 1" inlet and this is a 1 1/8" threaded fitting. It's my own fault for not looking at the pump when I bought it. Still works I just had to wrap electrical tape around the inlet fitting for it to seal. No biggie.
another attwood to fly high
Used this piece along with the 21003 hose extension to make my own over the side pump. Works great.
Turn an Attwood pump into a Fly High pump
I used this piece to connect to the bottom of a 1200 GPH Attwood pump. With a bit of hose and wiring I was able to create a Fly High pump setup for about 1/2 the cost. This fitting fit perfectly, is high quality, and is reasonably priced.
Works great and saves time!
This connector works great and saves time over the alternatives. Just be sure you buy the correct connector. This will not fit the tsunami 800 gph and below pumps. Those require the W732. I bought the wrong one the first time around.
Good product, fast shipping
best price I found