Carat Down

Introducing Engine Divider Panel Saver Kits

We are thrilled to announce that our Engine Divider Panel Saver Kit is ready for the boating aftermarket. We've had requests for a solution like this for years and it's really exciting to finally unveil this new premium product for v-drive wakeboard boats.

Anyone that runs additional ballast in the rear locker of their boat knows that bowing and warping are an all too common problem. The solution in the past for boat owners has meant a trip to the hardware store and a not-so OEM look once it's finished. Our new Divider Panel Saver Kit addresses both of those problems. Now you can get a OEM fit and finish without having to leave the comfort of your couch... until the installation.

This kit was developed by our team of in-house engineers and each one is handmade in Bend, Oregon. Built with a thick 6063 aluminum u channel bar and stainless steel hex hardware, these kits are designed to withstand a harsh marine environment. Each 19" bar is precisely cut, finished with radius edges, and then powder coated flat black for a factory appearance. After installation they are virtually invisible, and most people will think they came stock from the factory floor.

*Note: You will need to purchase two kits if you want to upgrade both sides.

Helpful Tools: 3/16" SAE Hex Head Wrench & 3/8" SAE Drill Bit, Measuring Tape

Installation of the Engine Divider Panel Saver Kit is relatively quick and easy. You only need the tools mentioned above to complete the install.

Buy the Engine Divider Panel Saver Kit»

Post Comments

0 Item(s)

Submit Comment

Please note, comments need to be approved before they are published.